Unlock your internal door with a registered fingerprint, the Connect SmartHome app or a mechanical key. The Connect SmartHome Smart Door Handle Lock stores up to 20 fingerprints and combines a fingerprint sensor with a black handle design.
Local Bluetooth app control
Use the Connect SmartHome app to register fingerprints, add or remove users, view unlock records and check battery levels. App control uses Bluetooth, so your phone needs to be near the lock. Wi-Fi is not required for setup.
Unlock records appear in real time while the lock is connected to your phone. When disconnected, records are stored on the lock and sent to the app the next time it connects.
Fingerprint access and passage mode
Complete app setup and register fingerprints before relying on the lock for access control. Initially, any fingerprint can unlock it. Once set up, unregistered fingerprints are no longer accepted.
Touch the sensor with a registered finger to unlock from outside. The lock automatically relocks after five seconds. From inside, turn the handle to open the door.
For passage mode, press and hold the interior Unlock button until it beeps. The door then stays unlocked and anyone can open it from outside. Press and hold the same button again to restore fingerprint-controlled access.
Check your door before purchase
- Indoor use only in a dry area away from rain, moisture and direct sunlight
- Existing single-cylinder lock preparation
- Door thickness: 35-55mm
- Backset: 60mm or 70mm
- Cross-bore diameter: 54mm
Check these measurements against your door and follow the supplied installation instructions. Consider professional installation if needed.
Battery power and backup access
The lock requires four AAA alkaline batteries, which are not included. Check battery levels in the app and replace all four batteries when low.
If the batteries run flat, use a mechanical key or connect a 5V USB power source to the emergency USB-C port for temporary power and fingerprint unlocking.